All About Painting Daily Digital

Painting Problems

Feb 1

Outside Residence Paint Problems: Painters in Riverside CA


Several things can impact the beauty of the paint movie on the exterior of your home. Your residence takes a great deal of abuse from the components-- from sun to rain to snow to hail.


Long-term direct exposure to any one of these problems can result in repaint failure, but recognizing how to determine the cause of the issue will undoubtedly enable you to address it the appropriate way so you can keep your home looking gorgeous and shield your financial investment.


In this article, we're going to highlight a few of the much more generally seen outside home painting issues and talk about the very best methods to fix them.


The Trouble: Peeling


The CausesHouse Painting

Old Paint: New layers of paint will only stick as well as the old coat( s) of paint they've been used over. The most usual reason we see peeling is due to inadequate scuffing of the old coatings before using new coverings.

Moisture: If water discovers its way behind the paint film, it will generally cause peeling off as it's trying to find its way out.

No Primer: If one of the most current paint coatings was applied straight over bare timber or a gleaming surface area, it could trigger a loss of bond in between the paint as well as the substratum it's being related to.


The Solutions

Pressure-wash, Scuff, & Sand: Pressure-wash to clean up the surface and eliminate any type of loosened or peeling paint. Scratch any remaining peeling locations and plume the sides with sandpaper or an electric sander.

Dry It Out-- Make sure that there are no leakages in the gutters or the roofing, that the surface is tidy and completely dry, and that every one of the cracks and butt joints in the house siding is well-caulked.

Primer before Paint: There are some circumstances where a guide is essential and some scenarios where it isn't. Please look at our Keying Blog to learn when to use a primer.


The Problem: Blistering


The CausesHome Paint

Wetness: The leading cause of this trouble is the exposure of the paint finishing to dew, high moisture, or rain quickly after drying.

Contamination: Paint over top of a surface contaminate such as dirt, oil, and so on can trigger a loss of attachment and cause these signs and symptoms.

Warmth: Too much warmth can cause issues with newly used paint when it's put over a surface that's too warm, typically due to extended direct exposure to direct sunshine.


The Solutions

Scuff & Sand: Hand scratch the blistered locations to remove any paint that is not well-adhered to the surface area. Feather the sides with sandpaper or an electric sander.

Do not Press It: Stay clear of the temptation of painting late into the evening when the dew will soon be working out in, or as well near the time when rain is anticipated.

Clean It Up: Always clean the surface well with a stiff-bristled brush or a stress washer, and make sure to use an excellent pre-paint cleaner/degreaser.

Use Good Judgment: When repainting the outside of your residence, try to focus on the sides of the house that are not in straight sunlight. If the surface area feels very warm to the touch, skip it and most likely to another side of the house.


The Issue: Alligatoring


The CausesPainting Problems

Oil-Based Paint: This is a condition that's unique to oil-based paint. Although using oil-based paint is not as typical these days, at once, it was extensively used. Oil-based paints are not nearly as versatile as acrylic latex's frequently utilized, cousin. As the oil finishes ages, it frequently will certainly split and fracture because it can't increase and contract with the surface. Often this problem occurs quickly when new oil-based paint is used over a flexible covering.


The Solutions

Out With The Old-- Eliminate as much of the old oil-based finishing as feasible by whichever method you favor (i.e., hand scuffing, chemical paint removing, etc.).

In With The New-- Replace the oil-based covering with 100% Acrylic Latex paint. Take care when using latex over oil as attachment of the brand-new to the old can occasionally be an issue. If the old coating is glossy, think about producing a "profile" on the surface for the brand-new paint to stay with by scuff-sanding it with sandpaper or an electric sander, and consider the use of a guide that will undoubtedly bond well to the old finish. To learn more about our pricing, check out this info.